Taking the plunge with SIP Trunks

We're moving! Blogspot has been a great way to start blogging, but it has limitations. We've just completed a brand new annex to the smartvox web site called the Smartvox Knowledgebase - it is a combined blog plus a complete archive of all the blogs and VoIP articles I've written in the last few years. Please visit the new Smartvox Knowledgebase at: http://kb.smartvox.co.uk/. To read the latest revision of this article on SIP trunks in Asterisk at the new site, follow this link: http://kb.smartvox.co.uk/index.php/asterisk/telephony-connections/sip-trunks-telephony-connections/taking-the-plunge-with-sip-trunks-part-1/

SIP Trunks are often talked about on the Asterisk wiki and forum pages; Many VoIP service providers offer them as a standard product; But just what is a SIP trunk and what can you use it for and how do you make it work with Asterisk? I will attempt to answer these questions in what I anticipate will be a 3 part blog, starting with the basics.

What is a SIP Trunk?
A SIP trunk uses standard SIP signalling, but the endpoints of the trunk are fixed - typically one end point is the ITSP - Internet Telephony Service Provider - and the other is your PBX (e.g. Asterisk).


The SIP Trunk will usually just be one segment in the entire end-to-end pathway of a call. It may be used for inbound/outbound or both types of call and a number of different calls can be active at the same time, all using the same SIP Trunk connection. However, to truly qualify as a SIP Trunk, it should be possible to associate more than one incoming number (DDI or DID) with the same account.

What do you connect to a SIP Trunk?
Normally, the equipment at the customer's premises will be some kind of SIP-enabled PBX. An Asterisk PBX is ideal for this role.

Although possible, it would be unusual and probably impractical to connect an IP Phone or softphone directly to a SIP Trunk. However, there is just about no difference in terms of the SIP signalling. The Asterisk configuration to connect to a personal VoIP account - the type normally used for a single IP phone or softphone - is almost identical to that used for a SIP Trunk account. The differences between personal SIP accounts and SIP Trunks are as much commercial as they are technical - greater capacity for simultaneous calls and greater provision of inbound numbers managed through a single SIP connection. The main technical difference is the ability of a PBX to extract the target DDI number and use it to correctly route inbound calls.

How do you connect to a SIP Trunk?
Sometimes it is necessary for the PBX to register with the ITSP, primarily because this allows the service provider to know where the PBX is located - its IP address. The service provider then knows to send your inbound calls to that IP address. Sometimes the connection is achieved without registration, simply using a pre-defined IP address. This latter option is more likely to be used for direct connections to carriers or for other high-end connections involving wholesale services.

Making and receiving calls over a SIP Trunk
Inbound calls delivered by the ITSP to your PBX will contain the DDI number that was called. This must be interpreted by the PBX to determine the routing of the call to a device - typically a phone, but could be to a ring group or ACD queue. More about the setup for inbound calls in part 2.

Outbound calls are sent to the ITSP by the PBX and, in response to an authentication challenge, it will also need to send credentials for authentication/authorisation. The challenge authentication/authorisation is required even if the PBX has registered. Again, there will be some more on this later.